Training methods of YMAA

Discuss training methods, physiology, pedagogy, psychology, morality. Conquer yourself, contribute. Please stay on topic.

Moderators: Dvivid, Inga, nyang

Training methods of YMAA

Postby Monsoon » Mon Feb 04, 2013 7:23 pm

I was watching the excellent DVD of YMAA training and was struck by a thought! (dangerous things)

Regarding the exercise where a cinderblock (breezeblock/not sure of correct terminology) is thrown into the air and caught by gripping along the top edge: although the catching hand should match the speed of the falling block, how common are fingerpad tears in the early adoption of this regime?

Also, it looked as though the block could be replaced by a kettlebell, but then I wondered whether the open nature of the catching hand (with the block) is significantly different from the closed grasping hand you would use if throwing a kettlebell.

Perhaps someone from the retreat centre could shed a little light on this?
peace and harmony

monsoon
Monsoon
Forum Guru
 
Posts: 241
Joined: Tue Sep 18, 2012 5:10 pm

Re: Training methods of YMAA

Postby Greg Jah » Wed Feb 13, 2013 10:42 am

Hi Monsoon,

I see you haven't received a reply to this question, so I figured I'd take a stab at it.

I don't own the DVD you reference, but I have done some chin na training with a concrete paving stone. I find the mechanics of the grip are different from the grip used when throwing a kettlebell, since the fingers naturally curl around the bell (so less "gripping" is needed) but lie flat against the paving stone (so much more gripping is needed). Also, when I throw the paving stone I typically throw it straight up and catch it straight down. While I squat while tracking & catching the stone, the exercise works my grip/ forearms & shoulders more than a kettlebell (which works the lower back & hamstrings more).

The paving stone I have is really rough concrete, so I use gardening gloves when doing exercises with it. I had some pretty bad abrasions when I started, hence the gloves.

As an aside, about a month ago I purchased some "Fat Gripz" to use when I lift weights. When used with pulling motions (pull ups, seated rows, upright rows) my forearms/ grip get a fantastic work out too. Bodybuilding dot com had a sale not too long ago, at which time I picked these up for about $30. I would NOT recommend paying more than that for these - what you're getting is an industrial grade rubber grip that you can snap around an existing bar. It's very convenient if you are going to use these on different bars, and the quality of the rubber appears to be very good, but I find it irritating that the price is so marked up.

Ross Enamait, a very inspiring strength/ conditioning coach based on the East Coast, has a FANTASTIC blog with a whole section dedicated to homemade equipment. If you go to this section of his blog: http://www.rosstraining.com/forum/viewt ... 7#section3 , and scroll down he has a section devoted to grip training. Master Ross was a lifesaver when my kids were younger and I had to rely on 20 minute no- or low-equipment home workouts to stay in shape.

Hope you find this helpful.

Best,

Greg
Greg Jah
Forum Contributor
 
Posts: 33
Joined: Fri Jan 18, 2013 12:01 pm

Re: Training methods of YMAA

Postby John the Monkey mind » Thu Feb 14, 2013 8:52 am

I did a little cinder block training a couple of years back. Just stop when the fingers hurt to much and get to red and scratched up to much. Build up gradually. It did not rip my pads off. :)
John the Monkey mind
Forum ÜberGuru
 
Posts: 482
Joined: Mon Nov 16, 2009 6:15 am


Return to General Training and Practice

Who is online

Users browsing this forum: No registered users and 4 guests

©2013 YMAA | About YMAA | Privacy Policy |Terms of Use | Permissions | Contact Us